Iso-octane
Reduced chemical reaction mechanisms: experimental and HCCI modelling investigations of autoignition processes of iso-octane in internal combustion engines
... 1100 K the Nancy iso-octane mechanism is comparable with the Chalmers mechanism and the ignition time does not differ more than 10% from the Chalmers mechanism. Even though the two mechanisms differ ...
33
The effect of iso-octane addition on combustion and emission characteristics of a HCCI engine fueled with n-heptane
... and iso-octane are primary reference fuels 共PRF兲 used to rate the autoignition resistance of ...while iso-octane is a branched-chain ...the octane rating ...while iso-octane’s ...
8
A micro-structured 5kW complete fuel processor for iso-octane as hydrogen supply system for mobile auxiliary power units Part I. Development of autothermal reforming catalyst and reactor
... 6.2. Testing of the 5 kW autothermal reformer 6.2.1. Experimental Below function of the test rig will be briefly explained, which was used to test the final reactor. Steam was generated externally by a conventional 8 kW ...
12
Computational Investigation of Weakly Turbulent Flame Kernel Growths in Iso-Octane Droplet Clouds in CVC Conditions
... the date of receipt and acceptance should be inserted later Abstract Numerical simulations of turbulent flame kernel growths in monodisperse clouds of iso-octane liquid droplets are conducted in conditions ...
30
Flame front behaviour in a stratified iso-octane/air turbulent V-flame
... turbulent iso-octane/air V-flames over a range in equivalence ratios that was constant among flame conditions, allowing specific effects of large-scale equivalence ratio gradients to be ...
7
Unregulated emissions of an HCCI engine operating on n-heptane/iso-octane blends
... the octane rating scale, and that detailed mechanism describing their oxidation in air are available[9, 10], it is of interest to analyze low engine load HCCI combustion for blends having different n- ...
8
ISO-Standardized Requirements Activities for Very Small Entities
... ISO/IEC 15504 separates processes and capability levels in two dimensions whilst CMMI handles them in a single dimension. However, it should be pointed out that separate process and capability dimensions may ...
14
Identification des paramètres du fluage par la méthode iso contrainte étagée des thermoplastiques
... Le matériau testé dans le présent travail est un polyamide 6 de marque TECAMID 6 fourni sous forme de feuilles épaisses de 07 mm extrudées. Les échantillons sont découpés [r] ...
4
Le passage d'une certification ISO 9001 à un management par la qualité totale
... Partie 2 Chapitre I Section 2 : Etude longitudinale de l’entreprise ICS 1.2. L’observation indirecte par l’analyse des documents et archives L’analyse des archives et documents en vigueur au sein de l’entreprise est non ...
472
Sistemas de gestión medio ambiental Las normas ISO 14000
... La empresa debe identificar las operaciones y actividades asociadas con aspectos ambientales significativos, ya que deben ser controladas para cumplir con la norma ISO 14001. Se debe tener controles operacionales ...
26
Implémentation de protocoles de communication ISO sur un mini-6 sous UNIX
... L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d’enseignemen[r] ...
104
Robust Iso-Surface Tracking for Interactive Character Skinning
... A contact operator is a composition operator able to define a con- tact surface (within the 0.5 iso-surface in our case) where the com- bined implicit primitives collide. Such operators were developed for long ...
12
Comment l'écrit travaille l'organisation : le cas des normes ISO 9000
... normes ISO 9000 ? La société TRITECH est née en 1988 et emploie aujourd’hui moins de 100 ...normes ISO 9000 vient non pas de la direction du groupe, mais du directeur de l’entreprise qui décide en 1993 de ...
27
Scientific basis of ISO standards on biomechanical risk factors
... of ISO standards which cover aspects of the work environment and workplace health and safety, the Subcommittee “Anthropometry and biomechanics” (SC3) - part of the ISO Technical Committee 159 Ergonomics ...
15
ISO standards on test methods for water radioactivity monitoring
... Distributed under a Creative Commons Attribution| 4.0 International License ISO standards on test methods for water radioactivity monitoring D. Calmet, S. Jerome, R. Ameon, A. Bombard, M. Forte, M. Fournier, M. ...
18
Pépite | Accréditation d’un laboratoire de recherche à la norme NF EN ISO 17025
... L’intérêt de cet outil est d’identifier les facteurs pouvant causer des ralentissements dans les pratiques voir d’annuler des expériences. Ce diagramme sera utilisé dans la partie concernant les apports qui ont été faits ...
77
French TimeBank: An ISO-TimeML Annotated Reference Corpus
... danlos@linguist.jussieu.fr Abstract This article presents the main points in the cre- ation of the French TimeBank (Bittar, 2010), a reference corpus annotated according to the ISO-TimeML standard for temporal ...
6
Coordinating International Standards: The Formation of the ISO
... ASA, ISO, and similar organizations can readily be understood as falling somewhere between the ...of ISO-like standard setting argued that the process would improve both the efficiency of markets and the ...
38
وتدويل المؤسسات الإقتصادية ISO نظم الإدارة البيئية 14000
... environnementale ISO 14000 emplacements distincts dans l'Union européenne et les conventions internationales, ce qui est devenu l'une des conditions d'exportation les plus importantes pour de nombreux marches ...
354
Robust iso-surface tracking for interactive character skinning
... A contact operator is a composition operator able to define a con- tact surface (within the 0.5 iso-surface in our case) where the com- bined implicit primitives collide. Such operators were developed for long ...
12