• Aucun résultat trouvé

cone calorimeter

Solutions for mid-rise wood construction: cone calorimeter results for materials used in standard exterior wall tests: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

Solutions for mid-rise wood construction: cone calorimeter results for materials used in standard exterior wall tests: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

... the cone calorimeter tests with the two water resistant barrier materials indicate that the paper impregnated with asphalt product (CCEX-WRB-A) ignited earlier and produced a higher peak heat release rate ...

63

Fire behaviour of electrical cables in cone calorimeter: Influence of cables structure and layout

Fire behaviour of electrical cables in cone calorimeter: Influence of cables structure and layout

... the cone data and HRR ...the cone calorimeter equipment where the cone heater was replaced by a burner and a portion of cable tray in vertical position was ...

11

Evaluating the fire hazard of lining materials using the OSU, cone calorimeter and full-scale fire test methods

Evaluating the fire hazard of lining materials using the OSU, cone calorimeter and full-scale fire test methods

... https://doi.org/10.4224/20358499 Access and use of this website and the material on it are subject to the Terms and Conditions set forth at Evaluating the fire hazard of lining materials using the OSU, cone ...

29

Solutions for mid-rise wood construction: cone calorimeter results for encapsulation materials: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

Solutions for mid-rise wood construction: cone calorimeter results for encapsulation materials: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

... the cone calorimeter to look down on a horizontally mounted sample at normal ...the cone hood/pyrometer bracket ...the cone hood was adjusted with an orifice ring a little bigger than the ...

60

Solutions for mid-rise wood construction: cone calorimeter results for acoustic membrane materials used in floor assemblies: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

Solutions for mid-rise wood construction: cone calorimeter results for acoustic membrane materials used in floor assemblies: report to Research Consortium for Wood and Wood-Hybrid Mid-Rise Buildings

... subfloor, material AM-6 had a significantly higher total heat release than AM-7 (159.2 and 21.2 MJ/m 2 , respectively). It was selected for use in the large-scale apartment tests. Table 3 shows cone ...

22

Results of cone calorimeter tests conducted at the NFL/IRC

Results of cone calorimeter tests conducted at the NFL/IRC

... "Standard Test Method for Heat and Visible Smoke Release Rates for Materials and Products using an Oxygen Consumption Calorimeter" (ASTM E-1354). American Society for Testing a[r] ...

337

The NRC sealed water calorimeter: correction factors and performance

The NRC sealed water calorimeter: correction factors and performance

... liquid calorimeter. If the water in the calorimeter is heated nonuniformly, buoyant forces will arise due to local density changes in the gravitational ...

14

Interactive Indirect Illumination Using Voxel Cone Tracing

Interactive Indirect Illumination Using Voxel Cone Tracing

... C. Crassin, F. Neyret, M. Sainz, S. Green, E. Eisemann / Interactive Indirect Illumination Using Voxel Cone Tracing Figure 3: Left: Illustration of the three steps of our real-time indirect lighting algorithm. ...

11

Second-order cone optimization of the gradostat

Second-order cone optimization of the gradostat

... in the gradostat to zero. The resulting algebraic equations specify a feasible set, which is nonconvex due to the nonlinear growth in each tank and, in some setups, discrete and bilinear mass flows between the tanks. ...

25

Approximate cone factorizations and lifts of polytopes

Approximate cone factorizations and lifts of polytopes

... convex cone K, called a K-lift of C, and the usual examples of K are nonnegative orthants R m + and the cones of real symmetric positive semidefinite matrices S + m ...

22

théoréme de point fixe sur un espace métrique partiel et cone

théoréme de point fixe sur un espace métrique partiel et cone

... Dans ce chapitre, on présente quelques résultats de la théorie du point fixe pour les fonctions du point fixe de Banach, et de Nadler pour les multifonctions contractantes défnies sur le[r] ...

65

L’apport du cone beam dans la gestion des instruments endodontiques fracturés

L’apport du cone beam dans la gestion des instruments endodontiques fracturés

... 57 Conclusion Malgré l’amélioration des séquences instrumentales la fracture instrumentale, reste un aléa thérapeutique fréquent et qui, même si elle n’est pas synonyme d’échec, entraine une désinfection incomplète du ...

78

The thioredoxin encoded by the Rod-derived Cone Viability Factor gene protects cone photoreceptors against oxidative stress

The thioredoxin encoded by the Rod-derived Cone Viability Factor gene protects cone photoreceptors against oxidative stress

... rod-derived cone viability factor, RdCVFL: rod-derived cone viability factor long, red, ox : oxidized, red : reduced, BSG1: basigin 1, GLUT1: facilitated glucose transporter 1 (SLC2A1), HEX: hexokinase, ...

50

A Calorimeter for determining heat transmission characteristics of windows

A Calorimeter for determining heat transmission characteristics of windows

... The objective of this paper is to present an approach for determining the heat transmission characteristics of windows and to discuss a new calorimeter design that will overcome som[r] ...

19

Normal Cone Approximation and Offset Shape Isotopy

Normal Cone Approximation and Offset Shape Isotopy

... and K 0 . An important consequence of this theorem is theorem 4.2 which asserts the isotopy between the offsets of the compact set and its sampling with almost the same sampling conditions as in the main theorem in [5]. ...

25

Development of a Portable Calorimeter: Prototyping and Design Information Gathering

Development of a Portable Calorimeter: Prototyping and Design Information Gathering

... portable calorimeter was undertaken for the purpose of creating a calibration standard for thermal ...portable calorimeter will provide such a calibration standard because thermal manikins can be calibrated ...

31

Conformal Factor Persistence for Fast Hierarchical Cone Extraction

Conformal Factor Persistence for Fast Hierarchical Cone Extraction

... of cone singularities for conformal surface ...the cone singularities extracted with previous techniques, while need- ing only one linear solving where previous approaches needed one solving per hierarchy ...

5

Rôle du Cone Beam dans le diagnostic radiologique des lithiases des glandes salivaires

Rôle du Cone Beam dans le diagnostic radiologique des lithiases des glandes salivaires

... Apparition d'un arbre mort Absence de remplissage du produit de contraste au-delà du canal principal et de ses branches primaires correspondant à des lésions chroniques des glandes s[r] ...

44

Specialization to the tangent cone and Whitney equisingularity

Specialization to the tangent cone and Whitney equisingularity

... cones, then by corollary 2.6, the germs (X j , 0) don’t have exceptional cones either. These two results allow us to restrict ourselves to the case where the germ (X, 0) is irreducible, which we will assume from this ...

109

Calorimeter for simultaneous measurement of thermal properties and dimensional changes

Calorimeter for simultaneous measurement of thermal properties and dimensional changes

... The tenlperature along the tube mas controlled with heater a t d so that heat exchange with the calorimeter along these leads was prevented.. All the other leads were thcrnlall[r] ...

7

Show all 205 documents...

Sujets connexes