• Aucun résultat trouvé

Design and prototype : a manufacturing system for the soft lithography technique

N/A
N/A
Protected

Academic year: 2021

Partager "Design and prototype : a manufacturing system for the soft lithography technique"

Copied!
158
0
0

Texte intégral

Loading

Figure

Figure 1-1-1  Schematic  illustration of the procedure for fabricating PDMS  stamps from a master having relief structures on  its surface[2]
Table 2.1  Material Filling Scenarios  and Potential Issues More  than needed
Figure 2-4 Illustration of Heating Transfer Processes There  are  several  design considerations  for the heating  curing process:
Figure 3-2.  Self  assembled  monolayers.  (A)  Schematic  diagram of an ideal,  single- single-crystalline  SAM  of alkanethiolates  supported on  a gold  surfaces  (B)  The variety of structural arrangements found  in SAMs  prepared by  FpCP when  the st
+7

Références

Documents relatifs

Vitamin E status and quality of life in the elderly: influence of inflammatory processes.. Lucile Capuron, Aurélie Moranis, Nicole Combe, Florence Cousson-Gélie, Dietmar

Un versant est voué à décrire les conditions de l’après- colonialisme (ce serait la postcolonialité) ; l’autre s’essaye à bâtir une épistémologie

Given the ground truth disparity from the KITTI stereo training data, we perform a breakdown analysis to under- stand the importance of the (1) matching results of the data-

The  program of  the intern  is in  a  first step  to investigate some bandwidth allocation algorithms with cyclic scheduling and to investigate the main performance. issues

Its Fourier transform, the so called r8dBhed radial density function (RRDF) then shows a sharp peak at 1,61 8 (Fig. The truncation effect of a peak function i drawn

1) Experiment 1 - Discrimination of the direction: Fig. 7 shows a box plot of the direction detection probability. 1 and 0 represent, respectively, the probability of detection of

Dans tous les cas, les termes étrangers introduits dans la langue vietnamienne ne sont pas l’objet d’une transcription mais bien d’un procédé de translittération phonologique (et

Its use in detection of the defects, particularly in the determination of corrosions .The contained information in the received signal makes it possible to determine