• Aucun résultat trouvé

Unraveling the effect of Bi2S3 on the optical,electrical and magnetic properties of?-MnS-based composite thin films

N/A
N/A
Protected

Academic year: 2021

Partager "Unraveling the effect of Bi2S3 on the optical,electrical and magnetic properties of?-MnS-based composite thin films"

Copied!
1
0
0

Texte intégral

(1)

Physica B: Condensed Matter

Volume 585, Issue 412121, 2020, Pages 421-421

Unraveling the effect of Bi2S3 on the optical, electrical and magnetic properties of

?-MnS-based composite thin films

Z.Amara, M.Khadraoui, R.Miloua, A.Boukhachem, A.ZIOUCHE

Abstract: (Bi2S3)x (?-MnS)1-x composite thin films have been deposited onto glass substrates using spray pyrolysis method. The structural and compositional investigations confirmed the co-existence of Bi2S3 and ?-MnS binary compounds in the thin films.

The surface morphology indicated that the increase in Bi2S3 concentration influences both the shape and the size of ?-MnS crystallites. The optical analysis via transmittance and reflectance measurements revealed that the band gap energy Eg decreased from 3.29 eV to 1.5 eV in terms of Bi2S3 content. The electrical parameters such as resistivity ?, mobility ?, carrier concentrations and Hall coefficient have been obtained by Hall Effect measurements. It is found than incorporation of Bi2S3 enhances the conductivity, and p-type conduction of ?-MnS could be converted to n-type at x = 0.5. The vibrating sample magnetometer measurement has revealed that (Bi2S3)x (?-MnS)1-x composite thin films have a ferromagnetic behavior at room temperature.

Keywords : ?-MnS, Bi2S3, Spray pyrolysis, Magnetic Properties

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

It is clear that the refractive index of the films increases with increasing annealing temperature and is presumably due to the increase in film packing density (decrease

was measured in situ during and after film deposition, as a function of film thickness, annealing temperature and annealing time, for pure Al films, films deposited in

The onset of interband transitions is thus determined and the Drude parameters of the conduction electrons are calculated The results are discussed in relation to the

Moreover, at liquid nitrogen tempe- rature the photoconductivity is observed on a natural single crystal of CuFeS, just at the energy region where the absorption edge is

It is clear even with materials devoid of long range order and with band tailing beyond the normal conduction and valence bands a forbidden gap exists and may be estimated

2014 A method for obtaining the optical constants by employing the correlation between the characteristic electron energy absorption spectrum of a substance with its

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Finally, the frequency dependence of the bolometer presented at different temperatures and at optimal current shows that both sensitive and fast uncooled bolometers can be