Abstract This memo presents specific implementation guidelines for running RSVP over ATM switched virtual circuits (SVCs)

This document accompanies the first submission of RSVP and integrated services specifications onto the Internet standards

If the DstPort in the SESSION object is zero but the SrcPort in a SENDER_TEMPLATE or FILTER_SPEC object is non-zero, then the message has a "conflicting source

There are 3 control packets used to open or close the session at the MATIP level for exchanging Type B data. 10.1.1 Session Open

In order to ensure interoperability between implementations that follow different options, RSVP over ATM implementations MUST NOT send RSVP (control) messages on the same QoS

The QoS signalling protocol is RSVP [1], the Resource ReSerVation Protocol and the service models One of the important features of ATM technology is the ability to request

To allow other routers to discover an OSPF interface automatically, the IP address, mask, Area ID, interface type and router priority information given must be registered with

The capability to monitor point to point traffic statistics between two routers and the capability to control the forwarding paths of subsets of traffic through a given

Due to the wide variety of existing signalling protocols and ATM service categories, and their support or non-support within ATM based access networks, this document takes