• Aucun résultat trouvé

Misalignment fault detection and diagnosis using AR model of torque signal

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Misalignment fault detection and diagnosis using AR model of torque signal"

Copied!
1
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

Misalignment fault detection and diagnosis using AR model of

torque signal

Authors

S Haroun, A Nait Seghir, S Touati, S Hamdani

Publication date

2015/9/1

Conference

2015 IEEE 10th International Symposium on Diagnostics for Electrical Machines, Power Electronics and Drives (SDEMPED)

Pages

322-326

Publisher

IEEE

Description

Misalignment is one of the most common mechanical faults in electrical rotating machinery, it can lead to partial or total breakdown of a motor in the long run may. This paper investigates the application of the Autoregressive Model of torque signal to detect and diagnose the misalignment fault. First, the torque signal obtained from experiment in different conditions: healthy condition, angular misalignment, and parallel misalignment fault are normalized to center the signal at zero mean and scales it to unit standard deviation. Then the AR model coefficients are extracted as features. Min Redundancy max Relevance (mRMR) feature selection technique is used to select the optimal features and reduce the dimension data. Finally, the Self Organizing Map neural network is used for classification of the different conditions. The experimental results show the effectiveness of the proposed method, were both angular and …

Références

Télécharger maintenant ( PDF - 1 Page - 242.18 KB )

Documents relatifs

Study of the effect of myofibrillar misalignment on the sarcomeric SHG intensity pattern.

Theoretical SHG-IP (dotted lines) is obtained from the myofibrillar schematic view for a laser beam focused and displaced along the horizontal line at the center of the

Sensor Fault Detection and Signal Improvement using Predictive Filters

INDUCTION MOTORS FAULT DIAGNOSIS USING MACHINE LEARNING AND ADVANCED SIGNAL PROCESSING TECHNIQUES

major contributions of the paper are summarized as follows: 1) Compare the fault diagnosis performance using the measured stator current and vibration signals; 2) Compare the

Evaluation of HD- sEMG grid misalignment with muscle fibers using nonlinear correlation

In fact, the aim of the proposed study is to find, as a first step, some parameters, estimated from obtained h² correlation matrix and calculated with different grid

Fast Modelling, Torque-Ripple-Reduction and Fault-Detection Control of Switched Reluctance Motors

Finally from the reliability point of view, an interturn short-circuit fault detection method and a rotor position estimation approach are investigated and validated

Sensor fault detection and diagnosis using zonotopic set -memberbership estimation

Using the zonotopic set-membership state estimation method presented in [15], the objective is to obtain a state estimation in the presence of abrupt sensors faults.. In this paper,

An Artifact-Based Framework for Business-IT Misalignment Symptom Detection

In this paper a new way of misalignment symptom detection have been presented, which is able to reveal typical symptoms along the four traditional alignment

Vibration signal-based bearing fault diagnosis using optimized multi-scale entropy and ANFIS network

In this work we have applied a fault diagnosis method based on using a complexity measure to detect and classify bearings related faults in an experimental test