• Aucun résultat trouvé

Effect of solution treatment temperature on theprecipitation kinetic of ?-phase in 2205 duplexstainless steel welds

N/A
N/A
Protected

Academic year: 2021

Partager "Effect of solution treatment temperature on theprecipitation kinetic of ?-phase in 2205 duplexstainless steel welds"

Copied!
1
0
0

Texte intégral

(1)

Materials Science and Engineering: A

Volume 496, Issue 1, 2008, Pages 447-454

Effect of solution treatment temperature on the precipitation kinetic of ?-phase in 2205 duplex

stainless steel welds

Riad BADJI, M. BOUABDALLAH, B. BACROIX, C. KAHLOUN, Khireddine BETTAHAR, Nabil KHERROUBA

Abstract: The effect of the prior solution treatment temperature on the ?-ferrite transformation in 2205 duplex stainless welds after aging at 850 °C has been studied. Microstructural examination showed that the ?-phase and M23C6 chromium carbides precipitate at the ?/? interfaces and within the ?-ferrite grains. Increasing the solution treatment temperature from 1050 to 1250 °C delays the

?-phase formation and favours the precipitation of intragranular secondary austenite ?2. The simulation of the ?-phase precipitation kinetic in the base metal, HAZ and weld metal, indicates a good agreement between the experimental fitted data and the modified Johnson–Mehl–Avrami model. The results indicate a marked sensitivity of the ?-phase precipitation kinetic to the solution treatment temperature. A high precipitation rate corresponds to a fine grained structure with ferrite enriched in ? forming elements (Cr, Mo)

Keywords : duplex stainless steel, welding, ageing, precipitation kinetic, Johnson-Mehl-Avrami model

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

The aim of the present study is to investigate the influence of the welding process parameters on the microstructure and mechanical properties of dissimilar weldement of 2205

Detailed microstructural examination showed the presence of higher ferrite amounts in the heat affected zone (HAZ), while higher amounts of austenite were recorded in the centre

Abstract : In this study, the effect of the artificial aging on the kinetics of the precipitationprocesses in the Al-Mg-Si alloy was investigated by differential scanning

In this study, the effect of the artificial aging on the kinetics of the precipitation processes in the Al-Mg-Si alloy was investigated by differential scanning

3 showing the number density of the solar wind particles, the electrostatic potential, the bulk speed and the total potential of the protons as a function of the altitude (in

A determination of the emitter effect of Cs and Ce is performed by phase resolved measurements of the electrode tip temperature T tip (ϕ), plasma temperature T pl (ϕ) and

The Dy ion and atom density is generally higher within the cathodic half period than within the anodic half period independently of the operating frequency (figure 3), the

Simos, Jesu’s Vigo Aguiar, A modified Runge-Kutta method with phase- lag of order infinity for the numerical solution of the Schr¨ odinger equation and related problems, Comput.