• Aucun résultat trouvé

Tantalum superconducting tunnel junctions for infrared photon counting

N/A
N/A
Protected

Academic year: 2021

Partager "Tantalum superconducting tunnel junctions for infrared photon counting"

Copied!
4
0
0

Texte intégral

Loading

Figure

Fig.  1. -2Scan of Ta Thin Film. Up: polycrystalline sputtered  at room temperature
Fig.  2. The different process steps (side view) and top view of  the final device.

Références

Documents relatifs

(4) Without conditioning upon photon detection, and since the gaussian nature of the initial vacuum state is pre- served by the Bogoliubov transform, the homodyne mea- surements

the average OC and EC concentrations (25.8 and 8.73 µg m −3 , respectively), the EC percentage of the total carbon (28%), and the total carbon percentage of the total PM 2.5 mass

mised method for material identification using a photon counting detector, Nuclear Instruments and Methods in Physics Research Section A: Acceler- ators, Spectrometers, Detectors

Les résultats sur les données numériques et physiques du fantôme ont démontré que la méthode DSR proposée conduit à une décomposition plus précise que la méthode

The XPAD3 (X-ray Pixel chip with Adaptable Dynamics) circuit is the next generation of 2D X-ray photon counting imaging chip to be connected to a pixel sensor using the bump

The XPAD3 detector is a hybrid pixel detector built of eight modules, each composed of seven XPAD3 photon counting circuits [4] connected to a 500 µm thick silicon sensor (Fig..

The maximum relative differences between simulated and experimental values, depicted in Table 3 , were below 11% for all event rates as well as for NECR and scatter fraction,

4,1517 Expected benefits of such contrast agents with respect to current solutions of small molecules are a high iodine concentration while retaining a low viscosity, and a