Déterminer les Facteurs d'Échelles des Deux Figures et Déterminer les Longeurs Manquantes (Facteur d'Échelle à un Intervalle de 0,5) (A)

Table 3. Since the structure of the disk is fully determined by the dust opacity, changing the dust-to-gas ratio simply implies scaling the gas density while all other factors like

I present an ap- proach to the latter two problems which relies on the Princi- pal Components Analysis (PCA), a method based on eigen- structure analysis, by taking a time

The difference between PyOC and SOC loss rates was reflected in a relative PyOC enrichment at all LTBF sites; the initial PyOC content ranged from 2 to 4% of the SOC while final

2 highlight examples within a carbon cycle modelling context of the three main challenges faced when performing a multiple data stream assimilation, namely, (i) the possible

(2006), briefly explained in Appendix B, a statistical uncertainty estimation model is used to estimate random uncertainties for ZS-DOAS instruments (UT-GBS and

Since the average absorbed dose in the primary beam area was not always the same (even after the automatic tube current modulation had been switched off ) when measurements were

de cette excitation à l’aide d’un vibreur. On obtient une courbe d’amortissement des vibrations du cristal pendant que le générateur est interrompu. Cette courbe est

caractérisent par une absence totale de fibrinogène plasmatique et pla­ quettaire. Elles sont causes d'hé­ morragies graves qui surviennent dès la naissance. Il s'agit