• Aucun résultat trouvé

Assessing degraded forest structures using UAV and SAR remote sensing data Clément Bourgoin

N/A
N/A
Protected

Academic year: 2021

Partager "Assessing degraded forest structures using UAV and SAR remote sensing data Clément Bourgoin"

Copied!
1
0
0

Texte intégral

(1)

Assessing degraded forest structures using UAV and SAR remote sensing data

Clément Bourgoin1,2,3*, Julie Betbeder1,2, Pierre Couteron4, Lilian Blanc1,2, N Baghdadi5, Louis Reymondin3, Peter Läderach3, Plinio Sist 1,2 and Valéry Gond1,2

1 CIRAD, Forêts et Sociétés, F-34398 Montpellier, France

2 Forêts et Sociétés, Univ Montpellier, CIRAD, Montpellier, France. 3 International Center for Tropical Agriculture (CIAT), Hanoi, Vietnam 4 UMR AMAP-IRD, Montpellier, France

5 IRSTEA, UMR TETIS, 500 rue François Breton, 34093 Montpellier cedex 5, France

Forest degradation accounts for 68.9% of overall forest carbon losses and changes forest structure. Due to the diversity (nature, intensity and frequency) of anthropogenic disturbances, multiple forest structures can be observed within the forest landscape mosaic. Remote sensing offers a unique opportunity to identify and characterize these structures. Very High Spatial Resolution (VHRS) optical imagery has the capacity to model forest canopy. SAR VHSR data which are independent of visibility conditions are capable to retrieve forest biomass, depending on the radar frequency and forest density. However, optical and SAR images have rarely been combined to study degraded forest structure. The aim of this study is i) to characterize the structure of a wide range of degraded forests types using optical UAV imagery and ii) to evaluate the potential of VHSR SAR imagery for scaling up.The investigated area is located in the human-dominated landscape of Paragominas municipality (Para state, Brazil). 52 UAV images of 25 ha (10 cm resolution) were acquired in September 2017 along the whole forest degradation gradient (from "undisturbed" to logged and/or burned forests) and to derive Digital Elevation Models. Four TerraSAR-X images were acquired in October 2017 (1.5m resolution) with different incident angles and polarizations. Three textural indexes based on the spatial variation in pixel radiance were derived from VHSR images (Fourier Transform Textural Ordination spectrum, the lacunarity and the skewness indexes) within different window sizes (from 50 to 200m). Generalized Linear Models were established between the UAV and SAR derived indexes and the forest canopy heights. Model fits and robustness were assessed by calculating the coefficient of determination (R-squared), the Akaike information criterion (AIC) and the root mean square error (RMSE). The combination of the three textural indexes from UAV images were able to capture the full gradient of canopy crown size distribution and canopy gaps and show a positive relation with the opening and lowering of the canopy. TerraSar X derived indexes showed most accurate results with the 26° incidence angle and HH-HV polarization. This quantification is highly informative for forested land use planning and policy makers to better understand and characterize degraded forests status from local to regional scale.

Références

Documents relatifs

The use of the k-means classification for deriving mangrove classes based on vegetation fractions appears to be a valuable approach for analyzing and comparing vegetation

Figure 2a shows the final delineation of urban areas (red polygons) obtained from the joint-use of Radarsat-1 and SPOT-4 images on Bucharest site compared to the reference

Significant relationships have already been established between radar mean intensity and forest biomass, but these relationships show a reduced sensitivity to biomass

The method is tested with multi-spectral IKONOS images acquired on areas containing six major communities (oak, pine, fir, primary and secondary high tropical forests, and

Pansharpening techniques and quality assessment Pansharpening methods allow merging multispectral images with medium/low spatial resolution (MS b ) and a panchromatic image

distributions for all stands based on field measurements (grey bars) and the four inventory approaches (ABA-MV area-based approach, mean values, ABA-DD area-based approach,

Three parameters are introduced for the high resolution POLSAR data clutter: the span, the normalized texture and the speckle normalized covariance matrix.. The asymptotic

Three parameters are introduced for the high resolution POLSAR data clutter: the span, the nor- malized texture and the speckle normalized covariance matrix.. The