• Aucun résultat trouvé

2D Device Modeling and Simulation / FET for Biomedical Applications

N/A
N/A
Protected

Academic year: 2021

Partager "2D Device Modeling and Simulation / FET for Biomedical Applications"

Copied!
1
0
0

Texte intégral

(1)

Seventh International Conference on Material Sciences

2D Device Modeling and Simulation / FET for Biomedical

Applications

Asma Bedia, Fatima Zohra Bedia, Boumediene Benyoucef

Abstract :

The aim of our work is to model physically the material of the biosensor-type FET (Field Effect Transistor) using drift diffusion model. This latter is given in the form of differential equations with partial derivatives, describing the physical behavior of charges and currents in each part of the device. Then we exploit our modeling results such as: the electronic properties of a FET (Field Effect Transistor)-based silicon, distribution of electronic potential, the current density and the concentration of electrons and holes.

Keywords : Modeling; Simulation; FET; Silicon; Drift Diffusion.

Journal Title / Revue : Physics Procedia, ISSN : 1875-3892, DOI: 10.1016/j.phpro.2011.10.006, Volume : 21, pp. 35–41, 2011.

Références

Documents relatifs

In the present study, the phase-averaged velocity and vorticity fields have been analyzed to determine the dynamics as well as the reattachment struc- ture, in relation with the

In the case of the older people suffering from Alzheimer’s disease, Adriana [7] learn his robot to adapt the level of interaction (easy, normal, difficult) with player

Biological factors such as saliva, acquired pellicle, tooth structure and positioning in relation to soft tissues and tongue are related to dental erosion development.. A very

We expanded a specific population of bone marrow-derived prominin- 1-expressing progenitor cells (PPC) from healthy heart tissue, analysed their plasticity, and evaluated their

client non-négligeable. En effet, si un contrat était signé avec une telle institution, cela nous permettrait d’avoir accès à un grand nombre de places possibles de distribution

For the variation of widths of charge distribution with light fragment products’ kinetic energies, approximately V-shaped curves were observed due to the large number of

Among published randomised controlled trials, there was little evidence of a difference in positive study findings between registered and non-registered clinical trials

Similarly, coatings obtained in PP60_2 conditions showed an adhesion strength of 35 ± 1 MPa ( Table 2 ). Both conditions exceed the 22 MPa in tensile strength required by FDA