S32 Measurement of the Residual Stress Field in an Aluminium Alloy 2014A Component of Complex Geometry

In the experiments on the AA2139 alloy, there was no PLC effect observed at room temperature in the investigated strain rate domain 10 −5 s −1 - 10 −2 s −1 for constant strain

To express component reuse at a behavioral level, we introduce modal au- tomata and acceptance automata as intuitive formalisms for behavioral interface description.. From

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

To model the full time-series of Stokes V line profiles (without the previous restriction of considering phase-averaged profiles only), we make a model of a synthetic, spherical

It was confirmed that, the external uniaxial stress superposes with the internal residual stresses and in elastic range of macroscopic deformation the process

Rémi HUSSON, Cyrille BAUDOUIN, Régis BIGOT, Edoardo SURA - Consideration of residual stress and geometry during heat treatment to decrease shaft bending - International Journal

Forrestal considers that the area A equals to the area of the cylindrical part of the striker ( Fig. In the case of thin plates, this area is smaller because a part of the conical

Forrestal considers that the area A equals to the area of the cylindrical part of the striker ( Fig. In the case of thin plates, this area is smaller because a part of the conical