• Aucun résultat trouvé

Beyond the no-slip boundary condition

N/A
N/A
Protected

Academic year: 2021

Partager "Beyond the no-slip boundary condition"

Copied!
9
0
0

Texte intégral

Loading

Références

Documents relatifs

System (BL) is different from the boundary layer system met in the former studies on wall laws: it has inhomogeneous Navier boundary conditions, instead of Dirichlet ones..

Along the North Ih Bogd segment, we estimated the horizontal slip rate of the Bogd Fault at Bitut, a site located 40 km east of the the Noyan Uul site (Fig.. There, a system of

No-slip and Free-slip divergence-free wavelets in three and higher dimension for the simulation of incompressible viscous flows... No-slip and Free-slip divergence-free wavelets

(B) Examples of clusters that are only present in one visit, depending if QC based gradient direction elimination was performed or not. An example is shown for each visit 1 to 3;

pour l’hydrogène ou l’hélium (les valeurs sont les mêmes). Les croix noires correspondent aux points de simulation que nous avons étudiés et les courbes noires sont des

Because the surface displacement rate is proportional to the slip rate on the subhorizontal plate interface in Guerrero, we suggest that the evolution of the slip rate during slow

The nonmodal stability analysis, however, reveals that slip has a very weak influence on the maximum transient energy growth of perturbations at subcritical Reynolds numbers..

[ 22 ] The results of the last section suggest that a transient wave or a static stress increase may enhance the likelihood of an impending earthquake on a fault which presents a