• Aucun résultat trouvé

Predictive Control of Power ElectronicsConverters in Wind Energy Systems

N/A
N/A
Protected

Academic year: 2021

Partager "Predictive Control of Power ElectronicsConverters in Wind Energy Systems"

Copied!
1
0
0

Texte intégral

(1)

International Conference on Electrical Engineering and Control Applications (ICEECA2017) 2017

Predictive Control of Power Electronics Converters in Wind Energy Systems

Badreddine BABES, Rachid AMRAOUI, Amar BOUTAGHANE, Amar Bouafassa and Mohamed Mezaache

Abstract : In order to make a wind power generation truly costeffective and reliable, an advanced control techniques must beused.

In this paper, we develop a new control strategy usingModel Predictive Control (MPC) approach for permanentmagnet synchronous generator based wind turbine system. Theproposed control law is based on two points: MPC-based torquecurrentcontrol loop for the generator-side converter to reach themaximum power point of the wind turbine, and MPC-basedcurrent control loop for the grid-side converter to satisfy the gridcode and to help improve system stability. A small-scale windturbine system prototype was built and tested in the laboratory,and the experimental results are provided to verify the validity ofthe developed control methods, MPPT algorithm andperformance of the system operations.

Keywords : finite-set model predictive control (FSMPC), Permanent Magnet Synchronous Generator (PMSG), Wind Energy Conversion System (WECS), Maximum Power Point Tracking (MPPT) Control, Grid Connected, experimental validation

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

Index Terms —Wave energy converter (WEC), doubly-fed induction generator (DFIG), predictive power control..

The main advantages of the proposed sliding mode power control strategy, according to the available literature [7], [8], [12], [15], [17] are: simplicity and robustness

In this paper, the Direct Power Control (DPC) is considered, so, the converter switching states are selected by a switching table based on the instantaneous errors between the

To meet the future generation of Permanent magnet synchronous generator wind turbines, a DC-DC boost converter is proposed at the machine-side to simplify the control and

The wind turbine requirements, such as MPPT and active and reactive power generation, are modeled as the reference control variables. The machine- and grid-side

Key words: Active power filter (APF), Adaptive neuro fuzzy inference system (ANFIS), Maximum power point tracking (MPPT), Predictive current control (PCC), Type-2 fuzzy

The nonlinear multi-loop (speed, current, voltage) controller thus obtained is formally shown, using Lyapunov stability, to meet its control objectives. Several

‘MPPT for PM wind generator using gradient approximation’, Energy Conversion and Management 50 (1), pp. ‘Maximum power point tracker of wind energy conversion system’,