• Aucun résultat trouvé

Validation of image restoration methods on 3D-printed ultrasound phantoms

N/A
N/A
Protected

Academic year: 2021

Partager "Validation of image restoration methods on 3D-printed ultrasound phantoms"

Copied!
6
0
0

Texte intégral

Loading

Figure

Table 1.The parameters in the table were modified in “File/Build Properties”
Table 2 lists the resulting FWHM and RMSE values. For the  settings used,  = 0.5 offers a higher spatial resolution gain than

Références

Documents relatifs

The results obtained are shown to improve a previously proposed recovery method, where the correlation between RF signals was taken into account by assuming the

كف غراف ءيش نم طقاستت نأ تارطقل في ريراوقلا لأمتو ، ةظفل فيظت اهنكل ( ءاوخلا ) ةللادلل ةايحلا هذهل يمدعلا دوجولا ىلع. نأ دجن ةديصقلا لكش ىلإ رظنلاب امأ

blurred cotton image and 4 kinds of algorithm recovery image after contour extraction The results of computing time on cotton images that computing time of four algorithms

The main focus of the present work is the expectation of the hitting time (to a given target set) of the process with restart, for which we obtain simple explicit expressions in

FIGURE 2 | Changes in (A) pre-dawn leaf water potential (9 PD ) and (B) relative water content (RWC) in varieties under three different water conditions: control (black points),

A common finding throughout the present review is that decreased sleep may be present time before BD onset in a variable percentage of patients ranging from 24% to 44% in

STEP 2 Find an optimal solution using the two-commodity subtour elimination constraints [3]. If integer valued STOP, if not go to

Equilibrated warping provides a good registration in three different types of images (i.e. tagged and untagged magnetic resonance images as illustrated in [7], and 3DUS images