• Aucun résultat trouvé

Performance evolution of fully and partiallytextured hydrodynamic journal bearingslubricated with two lubricants

N/A
N/A
Protected

Academic year: 2021

Partager "Performance evolution of fully and partiallytextured hydrodynamic journal bearingslubricated with two lubricants"

Copied!
1
0
0

Texte intégral

(1)

IOP Conference Series: Materials Science and Engineering

Volume 174, Issue 1, 2017, Pages 1-6

Performance evolution of fully and partially textured hydrodynamic journal bearings

lubricated with two lubricants

N. Tala-ighil, M. Fillon

Abstract: This study investigates the evolution of the main bearing performance of partiallyand fully textured hydrodynamic journal bearing. The viscosity effect is also analysed by themean of numerical simulations for two types of oil: the oil 1 (ISO VG 32, 31.3 cSt at 40 °C)has a lower viscosity than oil 2 (ISO VG 100, 93 cSt at 40 °C). Reynolds equation is solved byfinite difference and Gauss-Seidel methods with over-relaxation for various operatingconditions. It is shown that, under hydrodynamic lubrication regime, the improvement of themost important characteristics (the friction coefficient and minimum film thickness) of atextured journal bearing depend strongly on the lubricant viscosity and the journal rotationalspeed. The fully textured journal bearing is highly favorable at very low speeds while thepartially textured journal bearing is more suitable for slightly higher speeds. The gain inbearing performance due to the texturing of the bushing disappears at a critical speed of thejournal and then, for higher rotational speeds, the presence of textures becomes detrimental.

Keywords : journal bearing, texture, hydrodynamic, lubrication

Centre de Recherche en Technologies Industrielles - CRTI - www.crti.dz

Powered by TCPDF (www.tcpdf.org)

Références

Documents relatifs

One can observed that, for a fully textured journal bearing and for a partially (only the first one half of the bearing surface is textured) journal bearing, the positive effect

The treatment of rupture and reformation of the film fluid in the contact region, for a steady loaded circular journal bearing, are accomplished using the Reynolds and

In order to analyze the variation of the bearing characteristics with the depth of texture (along the y direction) for three texture geometries, we take the dimple size r=1 mm

The presence of textures over the entire surface of the bearing does not necessarily improve the hydrodynamic characteristics (friction reduction, increased

Texturing the contact inlet region (cases 10 to 12) has a modest and negative effect on the bearing performances; + 0.1% for the maximum pressure, -0.2% for the film thickness and no

The variations in the bearing static characteristics (load capacity, maximum hydrodynamic pressure, friction torque, axial film flow, attitude angle, and the energy dissipated in

The function of performance bounding two domains (domain of safety and domain of failure) is estimated for several geometrical configurations of a hydrodynamic

The function of performance bounding two domains (domain of safety and domain of failure) is estimated for several geometrical configurations of a hydrodynamic