• Aucun résultat trouvé

Effect of different surface treatments on the hydrothermal degradation of a 3Y-TZP ceramic for dental implants

N/A
N/A
Info
Télécharger
Protected

Academic year: 2022

Partager "Effect of different surface treatments on the hydrothermal degradation of a 3Y-TZP ceramic for dental implants"

Copied!
9
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

(1)

Article

Reference

Effect of different surface treatments on the hydrothermal degradation of a 3Y-TZP ceramic for dental implants

CATTANI-LORENTE, Maria Angeles, et al.

Abstract

Implant surface modifications are intended to enhance bone integration. The objective of this study was to assess the effect of different surface treatments on the resistance to hydrothermal degradation, hardness and elastic modulus of a 3Y-TZP ceramic used for dental implants

CATTANI-LORENTE, Maria Angeles, et al . Effect of different surface treatments on the hydrothermal degradation of a 3Y-TZP ceramic for dental implants. Dental Materials , 2014, vol. 30, no. 10, p. 1136-46

DOI : 10.1016/j.dental.2014.07.004 PMID : 25115704

Available at:

http://archive-ouverte.unige.ch/unige:43563

Disclaimer: layout of this document may differ from the published version.

1 / 1

(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)

Références

Télécharger maintenant ( PDF - 9 Page - 8.27 MB )

Documents relatifs

Comparative analysis of three different methods used to determine the elastic modulus for a choice of Tropical Guianese wood species

This study compares variability in the longitudinal Modulus of Elasticity (MOE) values, measured by three different methods, for eight tropical wood species covering a wide

Towards the prediction of hydrothermal ageing of 3Y-TZP bioceramics from processing parameters

In this article, we provide a predictive, phenomenological model of the influence of sintering conditions on the microstructure (amount of cubic phase, yttria content in the

EFFECT OF SURFACE ROUGHNESS ON THE KAPITZA RESISTANCE

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

A practical guide to performing multiple-point statistical simulations with the Direct Sampling algorithm

(Color online) 3D example with (a) first out of 10 unconditional simulations illustrating the effect of parameters t and n with f ¼0.5 and (b) influence of t and n (for f¼ 0.5) on

A note about the effect of surface states on the stability of the Si (110) surface

2014 The possible role of Shockley surface states in the stability of the Si (110) surface with respect to several deformation modes is investigated.. The dangling

Contribution to the degradation modelling of a photovoltaic cell under the effect of stochastic thermal cycles of a desert environment

In this study, and independently of any other environmental factor, we have arrived to simulate by the accelerated tests (which was the only possible

Study of bioactivity, corrosion resistance and fatigue behavior of Ti-12Mo-6Zr-2Fe alloy after different surface treatments

modérées aux premiers stades de l'immersion (0 et 1 jour), après 14 jours immergés dans SBF, elles ont montré les valeurs les plus faibles, proches de 0,2 μA.cm

Study of the effect of hydrothermal process conditions on pasta quality

The effect of the two selected process variables (steam pressure level and processing time) was studied according to the characteristics of pasta by using hydration