Surface Analysis of Isolated Nanoobjects by XPS
Texte intégral
Figure
Documents relatifs
The key mission of BM23 is to provide high-quality EXAFS in a large energy range (5–75 keV), with high S/N ratio up to large k-range, with a high degree of automation, featuring
Left: kinetic energy shift measured as a function of the delay between the 50 fs laser excitation and the synchronized isolated synchrotron pulse in the /25 SOLEIL filling
The study of the intensities is a useful tool to estimate ranges of electron temperatures present in the xenon plasma in these experiments and the analysis performed of the
This thesis is divided in three parts: the quantification of nuclear waste produced in a medical installation using neutron-equivalent sources (replacement of proton beam/target by
Table 3: Effect on line positions and intensities of the line P ff (7), when one applies a single spectrum fitting procedure to spectra 1-5, with the radius of the beam fixed at 0
The rotational clusters are fully resolved and the good signal-to- noise ratio has enabled precise measurements of transition intensities (92 cold band lines and 96 Dyad − Dyad hot
The HV diffractometer that will be described in the following sections is one of the two end-stations available at the SIRIUS beamline; the other end-station is a large
The design of the beamline combined with the available equipment (two-dimensional fast photon counting detectors, sophisticated high precision kappa diffractometer, a variety