• Aucun résultat trouvé

Numerical simulation of heat and mass transfer in bidispersed capillary structures: Application to the evaporator of a loop heat pipe

N/A
N/A
Info
Télécharger
Protected

Academic year: 2021

Partager "Numerical simulation of heat and mass transfer in bidispersed capillary structures: Application to the evaporator of a loop heat pipe"

Copied!
17
0
0

Chargement.... (Voir le texte intégral maintenant)

Texte intégral

Loading

Figure

Fig. 3. SEM pictures of wick structures with bimodal pore size distributions: (a) bidispersed wick and (b) biporous wick
Fig. 4. Pore network model: (a) Monoporous wick and (b) bidispersed wick. Note that, for simplicity, only the pores are randomly distributed in (a); whereas the network is depicted with a constant size of pores and throats in (b)
Fig. 5. Computational chart for the case with a liquid saturated wick. Reprinted from [7] with permission from Elsevier.
Fig. 6. Computational chart for the case with an unsaturated wick. Reprinted from [7] with permission from Elsevier.
+6

Références

Télécharger maintenant ( PDF - 17 Page - 3.58 MB )

Documents relatifs

Models of electrolyte solutions from molecular descriptions: The example of NaCl solutions

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Structural, microstructural and metabolic alterations in Primary Progressive Aphasia variants

10 Department of Psychiatry, Neurology and Rehabilitation University Hospital of Grenoble, Memory Research and Resource Center for Alzheimer’s

Intensity-modulated radiotherapy for prostate cancer with seminal vesicle involvement (T3b) A multicentric retrospective analysis

The following parameters were tested for recur- rences and survivals: treatment center; age; T stage at DRE; PSA; number of D’Amico risk fac- tors; MRI parameters such as

Analysis of heat transfer and flow patterns in a loop heat pipe : Modelling by analytical and numerical approaches and experimental observations

The condenser and the transport lines are discretized into small elements of volume as shown in Figure 4.1.. As suggested by Thome [88], the two-phase flow is characterized

High performance stucco to optimum moisture management in wood-frame stucco wall

However, the modified stucco mixes M3 (aggregates coated with hydrophobic chemical) and M4 (zinc stearate as admixture) show promising results with relatively low water

Numerical investigation of the thermohydraulic behaviour of a complete loop heat pipe

Heat losses to the ambient are less dominant for high heat loads whereas the total parasiti heat ux and the evaporation rate are.

Numerical study of heat transfer in a multilayerwall

Abstract : We proposed a study digital, by finite difference, heat transfer in a multilayer wall (three layers) subjected to radiation condition on the inner side and taking

Numerical study of heat transfer in a multilayer wall

We proposed a study digital, by finite difference, heat transfer in a multilayer wall (three layers) subjected to radiation condition on the inner side and taking into account