DS1402x MicroLAN TM Cables

If a printer is attached to a DS1410E, output pin 11 is connected to the printers BUSY signal (low only if printer is on–line and busy), and output pin 13 is connected to SELECT

The tactile feedback probe is ideal for situations where the iButton is stationary and the movable reader is brought in contact with it. Both types of probes are available in

For important information regarding patents and other intellectual property rights, please refer to Dallas Semiconductor data books.. DS9092R iButton TM

• Provides a simple, low–cost interface to an RS232C COM Port for reading and writing iButton devices (DS9097E required for programming DS198x Add–..

DS9100A Outer Contact (Ground) DS9100B Center Contact Cantilever (Data) DS9100C Center Contact Coiled Spring

The adapter then extracts the SCSI command from the parameter block and sends it over the SCSI bus, where the SCSI compatible disk controller in the drive

The G77 Infonnation Display Tenninal con- sists of a 1920-character display unit and a separate keyboard that is available in five styles.. Two-, three-, and

The read and write data commands use an internal MPA-II register called the MPA-II address counter, AC. This ad- dress counter works much like the Coax and Twinax ad- dress