• Aucun résultat trouvé

Temperature induced stresses on modified bituminous low-slope roofing systems

N/A
N/A
Protected

Academic year: 2021

Partager "Temperature induced stresses on modified bituminous low-slope roofing systems"

Copied!
15
0
0

Texte intégral

Loading

Figure

FIGURE 1: TYPICAL LAYOUT OF MODIFIED BITUMEN ROOFING SYSTEM
FIGURE 5: TESTED ROOFING SPECIMENS
FIGURE 9: MEASURED RESPONSE OF S1   FIGURE 10: MEASURED RESPONSE OF S2
FIGURE 13: MEASURED DIMENSIONAL CHANGE OF S4   FIGURE 14: MEASURED DIMENSIONAL CHANGE OF S5

Références

Documents relatifs

Alikhanyan National Science Laboratory (Yerevan Physics In- stitute) Foundation (ANSL), State Committee of Science and World Federation of Scientists (WFS), Armenia; Austrian Academy

Also at Department of Physics and Astronomy, Michigan State University, East Lansing MI; United States of America. Also at Department of Physics and Astronomy, University of

The grinder must implement the novel hybrid position/force control scheme: it must maintain a precise position for any force between zero force and the breakaway

A C-intein insert MUST contain the CDS of a POI preceded by a BsaI recognition site, any single nucleotide and overhang CC (GGTCTCNCAAC) and followed by overhang Z, any

Economic Development Urban Renewal Public Housing Tourism Clean and Green Environment Filial Piety Ambivalence Chapter 5 : Social Conservation

In doing so, it divides automated reading into four general subtasks: text categorization, named entity tagging, fact extraction and collection-wide analysis.. Special attention

Figure 5: (a) and (b) Feature points found in the in- tensity component of two di erent range images of a vase. (c) The two vase range images registered

The liver, spleen, kidneys, and red marrow dose per administered activity (AD/A admin) values were calculated with the Medical Internal Radiation Dose (MIRD) formalism and the