Characterization of printed circuit boards waste -influence of sample mass and particle size -example of zinc and nickel content
Texte intégral
Figure
Documents relatifs
The high purity (+ 99%) copper product obtained here from bioleachate using a single electrowinning process dem- onstrates that there is no need for solvent extraction.. The
In this paper, we show that the "preference of the majority" is represen- tative in an analogous fashion of the individual preferences from which it emanates in the sense
Powder XRD of SAC (Figure D2) confirmed the absence of aragonite and the only crystalline phase present is calcite. The morphology of SAC was investigated using SEM and compared to
The reduction of the uncertainty associated to the IRAS of a waste package of legacy metallic waste produced at CERN is related to the reduction of the uncertainties associated to
The main objective of this PhD thesis is the development of image analysis methods for characterizing the geometry and morphology of a dense population of particles by
Exercice 2.2. You toss a coin four times. On the …rst toss, you win 10 dollars if the result is “tails” and lose 10 dollars if the result is “heads”. On the subsequent tosses,
A perfectly flat, infinite surface does not give any diffusely scattered light, any amount of scattered light will therefore signal the presence of surface roughness,
Midzuno (1951) (see also Sen, 1953) proposed a sampling algorithm to select a sample with unequal probabilities, while estimating unbiasedly a ratio.. It may be of interest with