• Aucun résultat trouvé

Time-resolved double ionization with few cycle laser pulses

N/A
N/A
Protected

Academic year: 2021

Partager "Time-resolved double ionization with few cycle laser pulses"

Copied!
5
0
0

Texte intégral

Loading

Figure

FIG. 1. Deuteron kinetic energy spectra at an intensity of 5  10 14 W = cm 2 for linearly polarized pulse at durations of 40 fs (solid line) and 8.6 fs (squares)
Figure 2 compares results obtained with linearly ( 5  10 14 W = cm 2 ) and circularly ( 1  10 15 W = cm 2 ) polarized 10.5 fs pulses
Figure 2 (inset) shows the angle dependence of the 0.5– 4 eV fragments (solid line) and the 4 –10 eV  frag-ments (dashed line)
FIG. 4. Deuteron kinetic energy spectra for a linearly polar- polar-ized, 8.6 fs duration pulse at intensity of 2 : 8  10 15 W = cm 2 (squares)

Références

Documents relatifs

Influence of the hydrocarbon chain length of imidazolium-based ionic liquid on the dispersion and stabilization of double-walled carbon nanotubes in water.. Colloids and Surfaces

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

To achieve these goals, we sampled Botrytis on grapevine at fall in three French vineyards where sweet wines are produced: Alsace (Haut-Rhin, Eastern France), Anjou

The boundary layers over rigid fish were marked by separation of flow and transition to a turbulent boundary layer at speeds lower than observed in the flat plate. In general, local

Reliability criteria associated to a Web table are retrieved thanks to SPARQL queries (generated by using the ontology). Each answer associated with a given row of a Web table is

Degree of Polymerization (DPv) of paper as a function of aging in oil blended with acid mixture of 0.624 mg KOH/g, compared to samples aged in three different acids (formic, acetic

L’objectif de ce travail est la mise en forme du caoutchouc (mélange d’un caoutchouc naturel et un caoutchouc synthétique) par le procédé de moulage-cuisson pour fabriquer

NiMgAl–based catalysts were synthesized by coprecipitation, sol–gel, and impregnation methods, calcined at 700 °C for 4 h and tested in partial oxidation of methane in a