Adjusting island density and morphology of the SrTiO[subscript 3](110)-(4×1) surface: Pulsed laser deposition combined with scanning tunneling microscopy
Texte intégral
Figure
Documents relatifs
To determine a surface self-diffusion coefficient by mass transport, two conditions have to be fulfilled : (1) The initial surface shape should be simple in
A set of scanning electron microscope images was obtained to compare with the observed STM structure.. 3.- RESULTS
(3) The observation that Li (K) atoms form linear chains perpendicular to the dimer rows at the initial stage of adsorption appears to be contrary to the earlier experimental
L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des
Realizing the importance of characterizing a STM probe tip on an atomic scale, we have constructed a new instrument which combines a field ion microscope and scanning
sement dans les jonctions tunnel. Les trois definitions recemment proposees de la resolution du STM /1,3/ sont discutees de manisre critique. I1 est suggb- re que contraste
Moreover, we demonstrate the decisive influence of the ligand rather than the substrate on the electronic ground state of the metal centers, thus illustrating new vistas to
Ion bombardment (Ar+, 600 eV) on Au(JOO) generates vacancy islands whose shapes are strongly influenced by the anisotropy induced by the reconstruction of this