• Aucun résultat trouvé

Do not break any of the pins and straighten any that are bent

N/A
N/A
Protected

Academic year: 2022

Partager "Do not break any of the pins and straighten any that are bent"

Copied!
2
0
0

Texte intégral

(1)

INTEROFFICE MORANDUM TO: All District Managers

FROM: Jerry Grady

DATE: October 23, 1980

I have come up with the following notes as a possible addendum to the installation guide for the Yariable Disk Upgrade kit. These notes were compiled from my experiences with the upgrade kit. If you or any of our customers have comments or suggestions, please refer the comments to me for possible inclusion in an update of the documentation.

HARDWARE:

The following tools should be available to perform the upgrade 1 #2 phillips screwdriver

1 needle nose pliers 1 wire cutter 1 wire stripper 1 soldering iron 1 wire wrap tool or gun

When removing the screws on the right side of the disk drive, be very careful not to drop anything (i.e. screw or washer) behind the power supply. If this does happen, you must remove 6 screws and carefully pull the power supply board out and away from the chassis to retrieve the dropped item.

When installing the EIB on the back of the chassis, both cables must be folded back to be inserted into the cabinet.

The resistor pack from the old EIB should be used on the new EIB. Be extremely careful when removing the pack. Do not break any of the pins and straighten any that are bent. Pin 1 is marked on the EIB and pack. Match them up.

The hardware upgrade will take about 45 minutes to an hour for someone who is inexperienced with TERAK hardware and can read. For each unit after that 30 minutes is probably a reasonable estimate.

SOFTWARE::

Be sure that the first attempted upgrade of the Variable density software is made to a copy of a working diskette. Be sure the upgrade software agrees with the users software, i.e. Version 1.5, Version 2.0 and RT-11 V3B are all on different diskettes.

To move software on single density diskettes to dual density diskettes, the dual-density diskettes must be formatted and then using the Filer, under UCSD O/S, the directory of the dual density diskette must be zeroed and labeled. Then files may be copied one at a time (or with a wild card transfer) to the dual density diskette. Do not do a device copy, i.e T)ransfer #4:, #5:.

(2)

Using the Filer under the UCSD O/S, do an E)xtended listing of the files on the diskette to which the SYSTEM.8510.QB was copied. If any of the files SYSTEM.8510.QB, SYSTEM.8510.QX, or SYSTEM.8510.QX is past block 400, it is possible that the system will not boot. Under the 1.5 O/S you must delete files and K)runch the diskette until the the appropriate SYSTEM file is above block 400. Under 2.0, first K)runch the diskette specifying that the free space should be at the beginning of the diskette. Then T)ransfer SYSTEM.8510.QB to that diskette.

This software upgrade must be performed on all bootable diskettes.

If there is any likelyhood that the diskettes will be used on both a QX and a QB system, SYSTEM.8510.QX and SYSTEM.8510.QB should both be on the diskettes. Q2BOOT should be installed as the bootstrap.

Under the instructions for converting UCSD diskettes to variable density, the user should note that he must Q)uit the Filer after the file T)ransfers and before eX)ecuting BOOTER. (I.e. page 5, step 4a, or page 5, step 10a)

Références

Documents relatifs

example, when a router of the NSFNET Backbone exchanges routing or reachability information with a gateway of a regional network EGP is

2 Until a refrigerator-stable vaccine becomes available, however, varicella vac- cine will not be incorporated into the recommend- ed immunization schedule in Canada, as most

Enfile las barras de madera sobre el tope de las Patas (Parte A y Parte B), con los aguejeros en la parte baja de la Unidad Superior, como se muestra debajo.. Apriete con la

The static semantics of λ H shows the benefits of using a type language as ex- pressive as TL. We can now define the type constructors of λ H as constructors of an inductive kind

In my opinion, now the nomination completely satisfies all mandatory criteria for safeguarding cultural heritage: it is the element of Intangible Cultural Heritage,

The present element demonstrates its main demand and purpose with sufficient information that completely meet the Convention’s definition of intangible cultural heritage in

If, in relation to any Series of Notes, a as a result of any change in the laws or regulations of The Netherlands or of any political subdivision thereof or any authority or

Upon connection to the power outlet, the base is open for five minutes, after which the light shines either green or red (depending on whether or not you registered a handset in