• Aucun résultat trouvé

Computer-Aided Design for Microfluidic Chips Based on Multilayer Soft Lithography

N/A
N/A
Protected

Academic year: 2021

Partager "Computer-Aided Design for Microfluidic Chips Based on Multilayer Soft Lithography"

Copied!
9
0
0

Texte intégral

Loading

Figure

Fig. 1. A simple microfluidic chip based on multilayer soft lithography.
Fig. 2. Micado automates three key steps in the microfluidic design process: control inference, routing, and GUI generation.
Fig. 3. Language for specifying a microfluidic ISA. For each method of composing flows, the table indicates the input and output points of the combined flow, as well as any constraints on the original flows.
Fig. 4. Example of control inference. This example highlights the calculation of shared control lines; the valve placement steps are not shown.
+2

Références

Documents relatifs

Florian Herry, Frédéric Herault, Amandine Varenne, Thierry Burlot, Pascale Le Roy, Sophie Allais.. To cite

Different low density genotyping chips were designed according to two methodologies: a choice of SNP depending on a clustering of SNP based on linkage disequilibrium threshold or

روﺘﻜدﻝا : رﻴﺸﺒﻝا دﻤﺤﻤ قﻴﺒﻝ ﻲﻝﺎﻌﻝا مﻴﻠﻌﺘﻝا ذﺎﺘﺴأ سﺎﺒﻌﻠﺒ يدﻴﺴ ﺔﻌﻤﺎﺠ ﺎﺸﻗﺎﻨﻤ أ.. تﺎﺴﺴؤﻤﻝا ﻲﻓ ﺔﻴﻤﻴظﻨﺘﻝا تﺎﻌﻗوﺘﻝا وﺤﻨ ﺔﺴاردﻝا ﺔﻴﺠﺎﺘﻨﻹا عﺎطﻘﻝﺎﺒ مﺎﻌﻝا 6 - 5

In this thesis, we assume that the present value of a loan and the cost of its prepayment option are defined according to the intensity of default of the borrower, the short

Abstract—In this paper, we propose a successive convex approximation framework for sparse optimization where the nonsmooth regularization function in the objective function is

Therefore, the analyzed period of 1965–1991 of increas- ing geomagnetic activity should result in negative NmF2 and positive hmF2 trends, as our previous analysis has shown

In consequence subepithelial fibroblast network is necessary to integrate external signals and to provide the villi the adequate mechanical properties in response

[r]