• Aucun résultat trouvé

Elevated-temperature low-cycle fatigue behaviors of Al-Si 356 and 319 foundry alloys

N/A
N/A
Protected

Academic year: 2021

Partager "Elevated-temperature low-cycle fatigue behaviors of Al-Si 356 and 319 foundry alloys"

Copied!
8
0
0

Texte intégral

Loading

Figure

Fig. 1 Geometry and dimension of low-cycle fatigue test sample (unit in mm).
Fig. 2 Values of total strain amplitudes vs. LCF life for 356-T7and 319-T7 alloys.
Fig. 4 Stress-strain hysteresis loops of mid-life cycle for 356-T7 and 319-T7 alloys at 300 °C,                                                                                        at strain amplitudes of (a) 0.1%, (b) 0.2%, (c) 0.4% and (d) 0.6%
Fig. 5 Stable strain-stress hysteresis loops plotted with matched lower tip for (a) 356-T7 and (b) 319-T7
+3

Références

Documents relatifs

Lately, models coupling phase-transformation and plasticity have been proposed in an effort to describe permanent inelasticity effects which are experimentally observed in SMAs

xThe influence of heat treatment reproducing the brazing operation is negligible and insignificant on Glidcop Al-15 in terms of: metallographic and microstructure, tensile and

For each computed curve the value of the parameter  (linear dimension of non interacting regions) and the corresponding value of a (variance of the gaussian

De façon sous-jacente, nous nous demandons si la joie est radicalement distincte de la tristesse en ses signes d’apparition. La troisième question, « est-ce qu’on a le droit de

Les résultats de notre étude sont en faveur de l’intégration d’un module de simulation en réalité virtuelle dans la formation en chirurgie otologique des

Or, malgré les discours d’accompagnement de ces technologies à l’époque et leur reconduction sous des formes différentes tout au long de la décennie, il a fallu

Si l’émotion est au cœur de l’expérience touristique (Aho 2001, Bastiaansen et al. 2017, Tussyadiah 2014), elle est peu envisagée comme élément de valorisation de la

This induced a reduction of the amount ofparticles with size greater than 20 mm but had almost no impact on the production of fines (amount ofparticles smaller than 2 mm).