• Aucun résultat trouvé

Modelling and numerical simulation of water transfer in Proton Exchange Membrane Fuel Cells

N/A
N/A
Protected

Academic year: 2021

Partager "Modelling and numerical simulation of water transfer in Proton Exchange Membrane Fuel Cells"

Copied!
183
0
0

Texte intégral

Loading

Figure

Figure 2.3: Evolution of the invasion pattern with the contact angle (invading phase in grey) [7].
Figure 3.5: Example of the first layer of GDL pores with the three types of pores at the inlet.
Figure 3.8: Liquid water distributions from X-ray tomographic microscopy for the different designs and operating conditions obtained by Eller et al
Figure 3.9: Impact of α on the through-plane (a) and in-plane (b) saturation profiles
+7

Références

Documents relatifs

The impact of variations in the wettability properties of the gas di ffusion layer substrate on the liquid water distribution and the reactant gas access is studied from pore

Doped tin dioxide aerogel as alternative catalyst support for Proton Exchange Membrane Fuel Cells.. Guillaume Ozouf,

Study of diffusive limitations in Proton Exchange Membrane Fuel Cells (PEMFC).. Mathilde Brigaudet, Sandrine Berthon-Fabry, Christian Beauger, Nathalie Job, Marian Chatenet,

Performance loss of proton exchange membrane fuel cell due to hydrophobicity loss in gas diffusion layer: Analysis by multiscale approach combining pore network and

This paper presents an experimental study dealing with operation and degradation during an electrical short circuit of a proton exchange membrane fuel cell stack..

This paper presents an experimental study dealing with operation and degradation during an electrical short circuit of a proton exchange membrane fuel cell stack..

As the local membrane current density distribution is presumed constant for the hybrid model, a higher water vapor mole fraction is pre- dicted for this model at the anode

Simultaneous direct visualisation of liquid water in the cathode and anode serpentine flow channels of proton exchange membrane (pem) fuel cells.. Coating of stainless steel