• Aucun résultat trouvé

Alternative method for biomass combustion control

N/A
N/A
Protected

Academic year: 2021

Partager "Alternative method for biomass combustion control"

Copied!
10
0
0

Texte intégral

Loading

Figure

Figure 1 - Estimation of the Biomass
Figure 2 – Principle of the flame signature sensor
Figure 3 – Photograph of the flame signature sensor (by courtesy of CSEM)
Figure 5 – Example of sensor response to step changes in excess air for a forced-draught  diffusion burner, 180 kW (trained for 15% excess air)
+3

Références

Documents relatifs

Biomass mixing could be used to improve the combustion properties of resources which are currently not suitable for combustion.. We focused on determining and

Delineating environmental control of phytoplankton biomass and phenology in the Southern Ocean.. Mathieu Ardyna, Hervé Claustre, Jean-Baptiste Sallée, Francesco d’Ovidio,

In order to study the effect of inhomogeneous fuel distribution on the combustion process, a stratification of the fuel concentration was generated by non-symmetric port fuel

The first solution, VVTe is effective in HC reduction (50%) not very complex, but leads to a large increase of ISFC (>15%) due to HP IMEP (reduction of the expansion phase) and

Fuel poverty can be measured in a number of ways; therefore we analyze the impact of three different measurement approaches: the “10% ratio approach”, “the after fuel cost poverty

Such systems, called plasma electro-burners present number of advantages versus traditional technologies based on partial oxidation or combustion among which: their ability

This article examines the multiple aspects of fuel poverty in France according to different existing measurement approaches: the “10% ratio approach ” , “the after fuel cost poverty

One point is extremely important, for the minimization of the temperature fluctuations around the working temperature value using a servo-loop: it is related to the inherent time