Characterization of a Fe/Y[subscript 2]O[subscript 3] metal/oxide interface using neutron and x-ray scattering

ween high pressure piston cylinder devices for neu- tron scattering and diamond anvil devices for X-ray scattering goes a long way toward offsetting the much larger

High temperature devices (above 2 000 K) developed for that purpose, based on various heating techniques (induction, imaging furnaces, lasers, gas-flame heaters and

The essential parameters of superconducting magnets such as the maximum field, its homogeneity and sample access will be described from a technical and constructional

By comparison of the relative intensities of the peaks with the melting curves obtained by neutron diffraction (Fig. 3) and the isotherm data, it is clear that the

Abstract.- From the inelastic contribution to the neutron scattering on a PdMn spin glass the proba- bility distribution P(E) of exchange energies was determined which was in

To solve this discrepancy which might be essential to the interpretation of the observed energy gap at (001) in the 1-D phase by the Haldane conjecture, we

Our results show the power of Cu L 3 -edge RIXS to study spin excitations in the cuprates, since similar measurements using inelastic neutron scattering would be nigh impossible due

The information obtained with this short study of the phase structures of brine-oil-ACT mixtures at low ACT concentrations and close to the optimal salinities are in agreement with