• Aucun résultat trouvé

Surface modification of polyethersulfone hollow-fiber membranes by γ-ray irradiation

N/A
N/A
Protected

Academic year: 2021

Partager "Surface modification of polyethersulfone hollow-fiber membranes by γ-ray irradiation"

Copied!
8
0
0

Texte intégral

Loading

Figure

Table I  Hollow Fiber Spinning Conditions
Figure  1 shows  the  testing  system,  which  was  a  closed-loop circulation system
Table  Membrane  Type  111  Performance Data of Modified and Unmodified Hollow Fibers  (g/cm2  PWP  h)  PEG-3000  Solution Separation  PEG-6000  (%)  zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJIHGFEDCBA PEG-9000  zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJ
Figure  4  Effect of concentration on the flux for modified  HF23-100k-1 and unmodified HF23  a t  steady state;  AP

Références

Documents relatifs

Chapter 2 sets forth his philosophical position regarding the cultural importance and personal usefulness of writing; and in Chapter 3 he looks at the two

The present work aims at developing a predictive gas-liquid mass-transfer model for a binary gas mixture which integrates the liquid flow pattern (cross-flow). This

In conclusion, the partial shift in pea protein digestion from the rumen to the small intestine did not affect the portal net balance of N, but decreased N loss from the rumen,

the length/width of the structure, if one was present. The latter plot shows that rubble fields with lengths greater than 1 km are not uncommon in the Beaufort Sea, whether or not

/ La version de cette publication peut être l’une des suivantes : la version prépublication de l’auteur, la version acceptée du manuscrit ou la version de l’éditeur. For

The Norbixin spectrum exhibited signals not expected in the 30-40 ppm and 60-70 ppm region, indicating the presence of other compounds from the annatto extract in addition

The library aims to improve the availability of analytical standards of diet-related metabolites by bringing together scientists that can provide compounds as well as those who need

dowed growth process on silicon <111> substrates pre- sented in [6] is used to prepare wafers with dedicated regions for MOS and GaN devices.. This technique uses a