• Aucun résultat trouvé

Modulation of fluorescent light : flicker rate and light source effects on visual performance and visual comfort

N/A
N/A
Protected

Academic year: 2021

Partager "Modulation of fluorescent light : flicker rate and light source effects on visual performance and visual comfort"

Copied!
36
0
0

Texte intégral

Loading

Références

Documents relatifs

Les techniques basées sur l’utilisation des propriétés spectrales des matrices (organes entiers, couverts végétaux) [encadré 1] ont ces potentialités : elles sont non

However, even for partially resolved extended disks the integrated flux may be dominated by optically thick emission from either rings or from the inner part of the disk where the

In the latter scenario, diagnostic procedures that concomitantly evaluate both body composition parameters would be needed (e.g. the ratio between FM and FFM). Since the amount

In this scenario, recycling of bio-waste from urban areas and institutionalization of donation to food banks are the food waste reduction enablers most likely to be

Figure 8 Floe B1S1: (a) region where strength tests were conducted in two boreholes along Transect 1 and (b) surface topography along one of the drill hole transects,

6 Comparison of the proposed numerical models for the BCC lattice of spheres: (a) volume fraction of the pore domain (i.e. porosity of the BCC lattice); (b) effective gas diffusivity

In spite of their high capital cost, adding energy storage is considered a better long term solution than hybrid solar systems for large scale power plants.. For this reason,

not define a new coordinate frame and the velocity of the hull’s center of pressure expressed in the body-fixed frame can be used directly to determine the hull’s angle of attack