• Aucun résultat trouvé

Cover Letter for RSX-11M-PLUS Version 4.6

N/A
N/A
Protected

Academic year: 2022

Partager "Cover Letter for RSX-11M-PLUS Version 4.6 "

Copied!
1
0
0

Texte intégral

(1)

Computers & Communications Nashua, New Hampshire

Cover Letter for RSX-11M-PLUS Version 4.6

AV-GJ70K-TC

Version 4.6 is a maintenance release of RSX-IIM-PLUS software and documentation that contains several enhancements to make computing with RSX faster and easier. The RSX-llM-PLUS Release Notes contain descriptions of the enhancements, a list of new hardware products that are

supported in Version 4.6, and corrections to the RSX-IIM-PLUS documentation set, including corrections to the RSX-llM-PLUS System Generation and Installation Guide.

For information on installing your operating system, please consult the RSX-llM-PLUS Release Notes and the RSX-llM-PLUS System Generation and Installation Guide.

RL02 PRE GENERATED KIT USERS

The Pregenerated RL02 Kit is now included on the tape kit. Be sure to refer to the Release Notes for information regarding this change for the Pregenerated RL02 Kit, and the procedure for restoring this kit to an RL02 pack. This informa- tion is located in the Changes to Documentation for the RSX-llM-PLUS System Generation Guide and Installation Guide.

For TK50 and 4mm DAT tape distributions, there is only one tape. The beginning of the tape contains BRU8YS, followed by the RSX backup sets, the layered product corrections, and finally the pregenned RL02 kit. If an online sysgen is performed, the BRU used to copy the first backup set must support skipping over the bootable BRUSYS image.

Copyright ©1999, by Mentec, Inc.

Références

Documents relatifs

The DECnet-RSX software supports intertask communication calls for MACRO- 11, FORTRAN 77, COBOL, and BASIC-PLUS-2 programming; remote file access calls for FORTRAN 77, COBOL, and

This section describes new features, restrictions, and supplementary information for the Task Builder on Micro/RSX Version 3.0.. This change reduces both disk

TASK EXIT (only s-form supplied) EXIT$S This directive instructs the system to terminate the execution of the issuing task.. Therefore, no branch on carry clear instruction

WTSE$ causes the task to be suspended until the specified event flag is set. The following example illustrates task suspension pending setting of the specified

This command illustrates the simplest use of gives the name of a single file as output file as input. This chapter describes, first syntactic definition, the

Readers are expected to be familiar with the RSX-IIM Executive Reference Manual (DEC-II-OMERA-A-D) and to have some experience with the Task Builder and either

This section describes new features, a restriction, and supplementary information for using the Indirect Command Processor Library (Indirect).. For more information,

CDA then uses the data in the Executive symbol table file (RSXllM.STB) to format the binary input of the memory dump into readable analysis listings.. Finally,