The High Voltage distribution system of the ATLAS Tile Calorimeter and its performance during data taking

Keywords : Electromagnetic pollution, high voltage power line, induced current density, X70 steel pipeline, corrosion, Finite Element Method, Electrochemical impedance

In order to diagnose the effect of the electromagnetic pollution on the corrosion of the pipeline, the electrochemical impedance spectroscopy (EIS) measurements were used

general status readable VT_UI1 safety loop is closed write-/ readable VT_BOOL hardware voltage limit is to low write-/ readable VT_BOOL module status EHS readable VT_UI2 module

Short light pulses are sent simultaneously into all the TileCal photomultiplier’s tubes (PMTs) during ATLAS physics runs, thus providing essential information for ATLAS data quality

Relative variation of the integrator gain used by the Cesium calibration system obtained by comparing the gains of all the channels of the Tile Calorimeter.. conversion factor for

In the momentum range of 10 to 100 GeV, the correlation between the energy loss in the active and passive material of the Tile calorimeter (plastic scintillator tiles and

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des