• Aucun résultat trouvé

Correction to: “Modeling thinning effects on fire behavior with STANDFIRE”

N/A
N/A
Protected

Academic year: 2021

Partager "Correction to: “Modeling thinning effects on fire behavior with STANDFIRE”"

Copied!
2
0
0

Texte intégral

(1)

HAL Id: hal-02620069

https://hal.inrae.fr/hal-02620069

Submitted on 25 May 2020

HAL is a multi-disciplinary open access

archive for the deposit and dissemination of

sci-entific research documents, whether they are

pub-lished or not. The documents may come from

teaching and research institutions in France or

abroad, or from public or private research centers.

L’archive ouverte pluridisciplinaire HAL, est

destinée au dépôt et à la diffusion de documents

scientifiques de niveau recherche, publiés ou non,

émanant des établissements d’enseignement et de

recherche français ou étrangers, des laboratoires

publics ou privés.

Copyright

Correction to: “Modeling thinning effects on fire

behavior with STANDFIRE”

Russell A. Parsons, François Pimont, Lucas Wells, Greg Cohn, W. Matt Jolly,

François de Coligny, Eric Rigolot, Jean-Luc Dupuy, William Mell, Rodman R.

Linn

To cite this version:

Russell A. Parsons, François Pimont, Lucas Wells, Greg Cohn, W. Matt Jolly, et al.. Correction to:

“Modeling thinning effects on fire behavior with STANDFIRE”. Annals of Forest Science, Springer

Na-ture (since 2011)/EDP Science (until 2010), 2018, 75 (1), �10.1007/s13595-018-0696-8�. �hal-02620069�

(2)

CORRECTION

Correction to:

“Modeling thinning effects on fire behavior

with STANDFIRE

Russell A. Parsons

1&

Francois Pimont

2&

Lucas Wells

3&

Greg Cohn

4&

W. Matt Jolly

1&

Francois de Coligny

5&

Eric Rigolot

2&

Jean-Luc Dupuy

2&

William Mell

6&

Rodman R. Linn

7

Published online: 20 February 2018

# INRA and Springer-Verlag France SAS, part of Springer Nature 2018

Correction to: Annals of Forest Science

https://doi.org/10.1007/s13595-017-0686-2

In Table 2 in the original article, torching index (TI) and

crowning index (CI) values were incorrectly expressed in km/s.

The correct units are km/h. The original article has been

corrected.

The online version of the original article can be found athttps://doi.org/ 10.1007/s13595-017-0686-2

* Russell A. Parsons rparsons@fs.fed.us

1

US Forest Service, Rocky Mountain Research Station, Fire Sciences Laboratory, Missoula, USA

2 INRA, UR 629 Ecologie des Forêts Méditerranéennes, Domaine

Saint Paul, Site Agroparc, Cedex 9 Avignon, France

3

Department of Forest Engineering, Resources and Management, College of Forestry, Oregon State University, Corvallis, USA

4

Department of Forest Ecosystem and Society, College of Forestry, Oregon State University, Corvallis, USA

5 INRA, UMR AMAP botAnique et bioinforMatique de l’Architecture

des Plantes, Cedex 5 Montpelier, France

6

U.S. Forest Service Pacific Wildland Fire Sciences Lab, Seattle, USA

7 Environmental Sciences Division, Los Alamos National Laboratory,

Los Alamos, USA

Annals of Forest Science(2018) 75: 18 https://doi.org/10.1007/s13595-018-0696-8

Références

Documents relatifs

We were using Forest Inventory and Analysis (FIA) data to validate the diameter engine of the Forest Vegetation Simulator (FVS) by species. We’d love to have used the paired

The percentage of ecosystem C removal by harvesting plus burning was greater in the harvested treatments (20–29%) than in the CONT treatment (5%), but the differences between

Higher basal diameter was recorded 5 years after thinning with south aspect and lower basal diameter in control plots with North aspect (Supplementary Table 3).. Greater results

With respect to our experiment, individuals receiving the low piece rate are in a state of dissonance given the conflict between the cognitions “I exerted effort to earn a large sum

AMAP, en tant que membre de l’ATDN (Amazon Tree Diversity Network), a également été impliquée dans un article publié dans Science et récompensé par le prix William S.. Cooper

In Chapter 5, we use the adap- tively damped Picard iterations and a restricted unigrid method to solve nonlinear diffusion problems and ensure the positivity of approximate

For examining the upward fire propagation behavior of polymers, theoretical expression for the flame spread velocity [10,15] was utilized. Generation efficiency of smoke versus

3) The combustion efficiency and generation efficiency of CO 2 decrease and the generation efficiencies of CO and smoke increase as the generic nature of polymers changes