• Aucun résultat trouvé

Implementation of a CRAM solver in MENDEL Depletion Code System

N/A
N/A
Protected

Academic year: 2021

Partager "Implementation of a CRAM solver in MENDEL Depletion Code System"

Copied!
4
0
0

Texte intégral

Figure

Fig. 1. Relative discrepancy between concentrations computed by CRAM and RK4 with constant reaction rates over time.
TABLE I. Number of negative concentrations in one call to Bateman solver, for a 2631 nuclei depletion chain example.

Références

Documents relatifs

The range of the depletion interaction does depend on the depletant size, but for a given sphere volume fraction, a spot check at aspect ratio L=D  10 revealed only a 2% change in

In a second part, we provide a feedback law yet inspired by sliding mode which not only stabilises the pure chain of integrators in prescribed time but also exhibits some robustness

We also obtain results for the mean and variance of the number of overlapping occurrences of a word in a finite discrete time semi-Markov sequence of letters under certain

3: Evolution of the ratio of the total mean square nonlinear term in turbulent flow to the equivalent value in the Gaussian flow for short times (a) and long times (b)Z. Snapshots

Keeping the air flow rate and thermal power of the burner constant, it is shown that even for very small flow rates of hydrogen, as low as one percent of the thermal

Incorporating both of these parameters into the ELISpot procedure proved capable of greatly amplifying 35.1-fold increase the low grade CD8+ T cell responses directed against

Pour communiquer directement avec un auteur, consultez la première page de la revue dans laquelle son article a été publié afin de trouver ses coordonnées.. Si vous n’arrivez pas

The declination (DEC) axis was balanced first since the weights added or removed from the telescope tube would affect the balance about the hour angle (HA)