• Aucun résultat trouvé

Evolution de la microstructure des renforts fibreux lors du procédé d'infusion : caractérisation par micro-tomographie X

N/A
N/A
Protected

Academic year: 2021

Partager "Evolution de la microstructure des renforts fibreux lors du procédé d'infusion : caractérisation par micro-tomographie X"

Copied!
8
0
0

Texte intégral

Loading

Figure

Fig. 1. Experimental steps : a) Dry state, at 60 mbar. b) Wet state, stationnary 1D flow, at 60 mbar
Fig. 2. a) Sketch of the set-up for in-situ infusion in the X-ray CT. b) Detail of the set-up with the infused reinforcement
Fig. 3. a) A post-treated slice (YZ plane) extracted at X = 72 mm near the vacuum vent, at 60 mbar, with the representation of a Z profile
Fig. 5. Macroscopic decompaction evolution along the 1D flow X axis for several vacuum levels.
+2

Références

Documents relatifs

dans le cadre d’un nouveau dimanche thématique visant à mettre en relation collections et expositions temporaires, le Mah propose le 5 octobre une série de rendez-vous en lien

The thermodynamic material parameters of the Fe-Mn alloy (see Ref. 4 we show the phase-field simulations of dendritic growth with and without flow. On the left side we present the

Axial view images of: (a) RCT reconstructions using two image data sets acquired at two positions on the RC of the AC (EDEI case) and (b) RCT reconstruction using one single

The values of the swelling coef®cients are expressed in strain (%) per moisture content variation (expressed in %) and are calculated according to the

La comparaison des perméabilités équivalentes planaire montrée sur la figure 4.33 permet de constater que la perméabilité équivalente dans le plan est plus faible que celle du

Given the steady, apparently hard emission, the X-ray flux variability may well arise purely from the soft component.. The VLBI data reveal an extended radio source with a size of

Pour cela, la fabrication additive utilise la technique d’impression 2-temps qui, nous le rappelons, consiste à imprimer dans un premier temps le moule interne, pour

Experiments F02, F05 and, to some extent, F03, are examples of the first type of contact obtained during pressure solution in the present study, where roughness develops within