• Aucun résultat trouvé

Prediction of the ductility limit of magnesium AZ31B alloy

N/A
N/A
Protected

Academic year: 2021

Partager "Prediction of the ductility limit of magnesium AZ31B alloy"

Copied!
13
0
0

Texte intégral

Loading

Figure

Table 1. Isotropic hardening and plastic anisotropy parameters using slip and twin  model for magnesium AZ31B alloy (Kondori et al
Fig. 3. Engineering stress versus axial strain.
Fig. 5. Imperfection factor evolution.
Fig. 6. Influence of the adopted yield criterion on the predicted FLD.

Références

Documents relatifs

Its use in detection of the defects, particularly in the determination of corrosions .The contained information in the received signal makes it possible to determine

The ACT model considers two orthogonal components for the roughness as suggested by Ward (1992). The ACT model includes four parameters to describe the surface re fl ectance, a)

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Year-to-year hazard ratios of invasive breast cancer for users of combined HT in 1997-1998 compared with HT never-users in 1997-1998; year-to-year percentage of HT

LOUBOUTIN, Explicit upper bounds for residues of Dedekind zeta functions and values of L-functions at s = 1, and explicit lower bounds for relative class numbers

The driving experience of an electric powered wheelchair (EPW) can be disturbed by unpleasant dynamic and kinematic effects of the caster wheels, particularly

It was shown that two hardening models (power law and Voce) can give very different FLCs for the same imperfection value. The choice of the imperfection value was not discussed

The stereo kernel [6] which compares the minimal stereo subgraphs of two ordered graphs has one drawback : graph information are reduced to a bag of subgraphs without taking