• Aucun résultat trouvé

Effect of Ni, Mn, Zr and Sc additions on the performance of Al-Si-Cu-Mg alloys

N/A
N/A
Protected

Academic year: 2021

Partager "Effect of Ni, Mn, Zr and Sc additions on the performance of Al-Si-Cu-Mg alloys"

Copied!
367
0
0

Texte intégral

Loading

Figure

Figure 2.1  The growing trend of fifty years of uninterrupted aluminum alloys for North  American manufactured light vehicles
Figure 2.6 shows the major steps of the heat treatment which are normally used to improve  the mechanical properties of aluminum
Figure 2.10  Effects  of  Mg-content  on  tensile  properties  and  quality  index  of  Al-7%Si  alloy castings
Figure 2.11  Quality  chart  illustrating  the  influence  of  the  content  of  Cu  and  other  elements (Mg, Si, Fe, and Mn) and cooling rate, as indicated by arrows, on  the  strength  and  quality  index  of  Al-Si-Cu-Mg  alloys
+7

Références

Documents relatifs

NAIMI, Répartition des valeurs de la fonction ~ d’Euler et la fonction somme de diviseurs sur les entiers sans grand facteur premier. SMIDA, Sur les puissances

Compared to the Ms predicted by Ahlers' equations modified with the positive coefficient for Ni taken from Pops, the deviation still exists despite the fact that

Following the identification of the structural features of ternary or quaternary phases (T' or 8', TI, S' or S, T2) coprecipitating with 6'-A13Li, the specific

This proof stress increment with increasing magnesium content is probably due to solid solution strengthening, the magnitude of which is similar to that observed when

D’un autre côté, nous avons présenté quelques recherches dans le domaine des systèmes intelligents qui avaient pour objectif de créer des systèmes computationnels permettant

En développant, dans cet article, un cadre global permettant d'appréhender l'utilisation de l'hypertexte comme un travail collaboratif où interviennent le système, la tâche et

Après avoir défini les archives d’architecture, présenté les types de documents relatifs aux activités architecturales (produits de manière traditionnelle comme

end=etiq (read uniquement) permet de se positionner ` a l’´ etiquette etiq en cas de fin de fichier atteint pr´ ematur´ ement. eor=etiq (read uniquement) permet de se positionner `