• Aucun résultat trouvé

A simple and generic CAD/CAM approach for AFM probe-based machining

N/A
N/A
Protected

Academic year: 2021

Partager "A simple and generic CAD/CAM approach for AFM probe-based machining"

Copied!
8
0
0

Texte intégral

Loading

Figure

Fig. 1 illustrates the CAD/CAM approach followed in this study. Two different  freely available software were used to implement the CAD and CAM stages of  the  process
Figure 2: Designed pattern  Figure 3: Machined result

Références

Documents relatifs

Abstract: In order to effectively increase the resonance frequency and the quality factor of atomic force microscope (AFM) probes, a novel oscillating probe based on a dog-bone

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

probe’s data. The results are plotted in fig. The error bars take into account the standard deviation of the mass and the stiffness of the cantilever during the dipping. Our range in

The project aims to develop a new type of milling machine to simplify the stages between the design stage in CAD software and the manufacture of the designed

For this purpose, the optimization of the tool axis orientations is performed using a surface model for the tool path which allows integrating kinematical limits of the machine

i) The potential and charge distribution near the surface region behave rather like those for the case of a.. metal (the necessary qualification will be

Il y a aussi des dates qui en principe sont fixes, mais dans la pratique peuvent être déplacées de quelques jours pour coïncider avec un week-end, quand le

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des