• Aucun résultat trouvé

Ab initio calculation of the thermal conductivity of indium antimonide

N/A
N/A
Protected

Academic year: 2021

Partager "Ab initio calculation of the thermal conductivity of indium antimonide"

Copied!
8
0
0

Texte intégral

Loading

Figure

Table 1. Phonon frequencies (in cm −1 ) of InSb at 300 K at high-symmetry points (Γ, X and L points) of the Brillouin zone

Références

Documents relatifs

atmospheric pressure, the elastic constants for alumi- nium and lithium, calculated from the first-principle, pressure-dependent, local pseudopotentials we are using in this

In this paper two models of phonon scattering at solid-solid interfaces have been used to calculate the cross-plane thermal conductivity of active region of quantum cascade laser.

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The solar wind pressure increase caused a brightening of the dayside auroral oval, and poleward moving au- roral forms (rayed arcs) developed in the pre-noon sec- tor at 74–76 ◦

Thus, the thermal conductivity of the bentonite studied by Kahr and Müller – Vonmoos (1982) was higher than that studied in the present work at the same values of dry density

Abstract.- The dependences on temperature of superconducting materials bulk samples were measured using the continuous - flow helium cryostat developed in Research Institute

For the enriched sample, the specific value of the thermal conductivity at the peak is different, however the thermal conductivity obtained from theory between 3 K and 10 K and

Abstract - An application of the molecular dynamics simulated annealing method for performing total energy calculations is made to the study of the micro- scopic structure of