• Aucun résultat trouvé

Influence of phase transformation anisotropy on transformation surface around a crack tip

N/A
N/A
Protected

Academic year: 2021

Partager "Influence of phase transformation anisotropy on transformation surface around a crack tip"

Copied!
3
0
0

Texte intégral

Loading

Figure

Figure 2 - Mode I, Anisotropic Martensite Phase Transformation  onset surface under plane stress condition
Figure  3  -  Mode  II,  Anisotropic  Martensite  Phase  Transformation onset surface for plane stress

Références

Documents relatifs

With the increase of milling time all Co atoms became dissolved in the bcc Fe and the final product of the MA process was the nanocrystalline Fe (Co) solid solution with a mean

(usually a vertex of the single crystal yield surface, when five strain rate components are prescribed) which brings more than five systems in the Schmid

Moreover, when the surfaces come into contact, the asperity heights and their relative locations are uncertain, consequently, the resulting asperity contacts are

They are based on simulation results obtained from synthetised texture data with a dynamic rolling model coupled with a BEM model providing tyre belt radial vibration induced

Thus, in the case of systems for which the omega structure is a low temperature metastable phase, close to the transition temperature the free energy of formation of an

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

Clearly, the value of the Lyapunov exponent obtained in the favorable case f + = f − sabout 0.68d is very close to ln 2, so that the present system clearly succeeds in reproducing,

As this point is rarely addressed in literature, the minimum recovery strain is also investigated in the present study and inverse pole figures of transformation strains for