Low Power Reconfigurable Controllers for Wireless Sensor Network Nodes

ZigBee nodes are composed of processor module, wireless communication module, temperature humidity sensor module and power module.. Figure 2 shows the structure

1A, the approach described in [1] was to acquire temperature and humidity values (considering low cost and low power components) with a Bluetooth communication system for

They suggest that contemporary genetics-in flected clinical practices (as found for example in oncology and psychiatry) are subjected to a three-fold trans- formation: the emergence

The kernel function evaluated on two data samples in this setting outputs a linear operator (a matrix in the case of finite-dimensional output spaces, K(x, z) ∈ R p×p with p

The system is implemented in CMOS 0.35μm AMS technology and consists of a reconfigurable bank of SCs, which is the power source of the node, a control unit and a LDO

The same behavior (connectivity in function of temperature) is observed for the worst case deployment, but with a noticeable mean power saving with Stop-Resume, because the amount

In the article a new method for relative location estimation of mobile nodes in wireless sensor networks based on IEEE 802.15.4 standard has been proposed.. This approach uses link

The first wireless repeater is connected to the central server using standard interfaces (for example, a virtual com-port over the USB interface). An exemplary network