• Aucun résultat trouvé

Direct numerical simulation of nucleate boiling in zero gravity conditions

N/A
N/A
Protected

Academic year: 2021

Partager "Direct numerical simulation of nucleate boiling in zero gravity conditions"

Copied!
14
0
0

Texte intégral

Loading

Figure

Fig. 1. Schematic of the problem and reference frame used to establish the analytical model.
Fig. 2. Computational domain, initial conditions (temperature field and initial vapour seed) and boundary conditions
Fig. 3. Results for Ja c =Ja e ¼ 5 and h a ¼ 50  . Temporal evolutions of the equivalent vapour radius (a) and spatial distribution of temperature along the wall (z ¼ 0) (b) for different grids (dr in l m)
Fig. 3 (a) for the different grids, until the stationary conditions are
+6

Références

Documents relatifs

This work adds one optimization technique to the bag of tricks of arithmetic designers: lossless differential table com- pression can reduce up to a factor two the storage

Our goal is to use the redundancy formalism to realize a real coordination of the two arms with an image based control, while satisfying additional constraints such as avoidance of

Although no significant change in aggregation rate was observed for normal Hamaker coefficients, making the Hamaker coefficients low enough such that the thermal

Keywords: Fluid flow, surface tension, numerical simulation, Level-Set method, oscillating drop

Numerical tools must be developed to deal with the normal velocity jump condition, to determine accurately the thermal field close to the interface and to deduce the boiling mass

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The methodology is illustrated on the line following problem of a sailboat and then validated on an actual experiment where an actual sailboat robot, named Vaimos, sails