• Aucun résultat trouvé

Young’s modulus repeatability assessment using cycling compression loading on cancellous bone

N/A
N/A
Protected

Academic year: 2021

Partager "Young’s modulus repeatability assessment using cycling compression loading on cancellous bone"

Copied!
7
0
0

Texte intégral

Loading

Figure

Fig. 1 Calcaneus specimen embedded in epoxy resin
Fig. 3 Stress–strain curve and zone of interest (black stars) used for the Young’s modulus calculation
Table 1 Mean Young’s modulus, standard deviation and coefficient of variation (per cent) of each specimen

Références

Documents relatifs

These traffic data, recorded by a bridge WIM system over more than 7 months, combined with the influence lines measured in 1995 provided an estimation of the lifetime of the

This paper also describes a new modulus switching technique for the DGHV scheme that enables to use the new FHE framework without bootstrapping from Brakerski, Gentry and

In the present study, a 3D ‘finite element based’ digital image correlation method is used to determine displacement and strain fields of trabecular bone based on the

In this letter we argue that methods developed for fiber microscopic systems [10] are also useful at the macroscopic level, and draw an analogy between the effect of

We propose a framework for blind multiple filter estimation from convolutive mixtures, exploiting the time-domain sparsity of the mixing filters and the disjointness of the sources

This model predicts the final residual stresses field after Proof load and the stabilized stress cycle when service loading is applied.. The predicted residual stress field from

Pour combler l’absence d’une littérature pour la jeunesse proprement dite et en même temps répondre à la demande d’un public nouveau et d’une politique

The genetic analysis of water relations in the Syrah×Grenache progeny revealed that reduction in the transpiration rate induced by soil drying was not the only factor to be