Estimation of crack opening from a two-dimensional continuum-based finite element computation

It is assumes that the plastic strains and stress are the source of dissipation and a comparison between plane stress/plane strain dissipation in the vicinity of crack tip is

This test is about clamped–clamped isotropic beam submitted to a localized pressure. We focus on the behavior of the approach on a quite severe test and its capability to capture

Using the M-integral approach, we develop a method for sepa- rating mixed-mode fractures in viscoelastic media during the creep crack growth process.. The M-integral approach

This abstract briefly describes a novel continuum finite strain formulation of the equilibrium gap principle, introduced in (C LAIRE , H ILD et R OUX , 2004) at the discrete level

The objective of the present work is to validate a recently proposed FE-based image registration method with mechanical regularization, named equilibrated warping [11], for

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des

The example of crystalline/amorphous metallic composites is typical (Figure 2.2d): the flow stress of the amorphous phases is strongly dependent on both the strain rate and

encoded by ABCB1 gene, has already been suggested to be a determinant of TAC PBMC disposition [4–6]. However, many other drug transporters, such as multidrug resistance proteins