2D thermal finite element analysis of sticker breakout in continuous casting.

A study was conducted to see the effect of addition of carbon black and diatomite to natural silica (sand) for a mould powder used in Arcelor Mittal Steel Annaba. Keywords :

The morphological, thermal and structural studies were followed by electron scanning microscopy (MEB), differential scanning calorimetry (DSC/ATG) and X-ray diffraction (XRD) using

The morphological, thermal and structural studies were followed byelectron scanning microscopy (MEB), differential scanning calorimetry (DSC/ATG) and X-ray diffraction (XRD) using

The morphological, thermal and structural studies were followed by electron scanning microscopy (MEB), differential scanning calorimetry (DSC/ATG) and X-ray diffraction (XRD)

Lower thermocouple estimation + _ Model Alarm signal Algorithm Casting speed Alarm signal of abnormal event Upper thermocouple measurement.. Lower

Among the principal factors which contains in the continuous casting process, there are two things, the molten steel level in the ingot and the extraction speed, the variation of

This paper addresses the simulation of steel continuous casting (CC) using two non steady-state approaches: a slice method and a global method.. Both methods can take into

L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des