• Aucun résultat trouvé

Three-dimensional microscale simulation of colloidal particle transport and deposition in model porous media with converging/diverging geometries

N/A
N/A
Protected

Academic year: 2021

Partager "Three-dimensional microscale simulation of colloidal particle transport and deposition in model porous media with converging/diverging geometries"

Copied!
9
0
0

Texte intégral

Loading

Figure

Fig. 1. Geometry and meshing of the two configurations considered: (a) tapered pipe; (b) venturi tube.
Fig. 3. Variation of deposition probability versus N at different Pe for the tapered pipe.
Fig. 7. Spatial distribution of the density of deposited particles along the z coordinate at different N for Pe = 0.0014.
Fig. 10. Variation of Γ final /Γ RSA versus Péclet number: (a) venturi tube; (b) tapered pipe;

Références

Documents relatifs

Sur le Massif armoricain, le développement de l'hydrogéologie en tant que science est en grande partie lié aux problèmes d'alimentation en eau potable et aux

Dans plusieurs autres espaces frontaliers ouest africains le passage exact n’est pas connu. Les zones qualifiées de no man’s land peuvent donc être très vastes ou juste

During the period of steady northward IMF after the reversal the convection pattern was observed to reconfigure slowly: a region of large westward velocities progressively

Echim and Lemaire [2005] showed that the two-dimensional boundaries of such localized plasma structures (plasmoids, jets, and clouds) are characterized by a nonvanishing

The analytical solution and breakthrough curves of the random walk model were in good agreement for the three kinds of test made: variation of the diffusion coefficient, variation

Agnolin and Kruyt (2006) examine the linear elastic behavior of frictional assemblies of disks of coordination number between 3.5 and 5, and estimate their shear modulus in

And finally, the hrSPH method resolved the three-dimensional isotropic turbulence flow with high Reynolds number on a coarse mesh using Smagorinsky

In this situation, it has been shown that particles dispersed in a wetting fluid are entrained in the coating film when the thickness at the stagnation point is larger than a